Troubleshooting; Accessories - Rothenberger PIPECUT mini basic Bedienungsanleitung

7

Troubleshooting

Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Symptom
Machine cannot be
switched on
Rechargeable bat-
tery almost empty,
an LED on the
rechargeable battery
is flashing
Overload, machine
switches off
The machine
switches off at a
sudden increase in
load
Saw blade jams
when the machine is
advanced
Burn marks on the
cut surfaces
Chip ejection blo-
cked
8

Accessories

You can find suitable accessories in the main catalog or at www.rothenberger.com
Possible Reason
Discharge the rechargeable bat-
tery
Rechargeable battery not engaged
in end position
Electronic system protects the
rechargeable battery from deep
discharge
A sustained load has overheated
the machine or the rechargeable
battery. A warning signal is
sounded (constant bleeping).
It will go out after max. 30 seconds
or after the switch trigger is re-
leased.
The sudden increase in load also
causes the current that is required
for the machine to rise. This rise in
current, which occurs when there
is a sudden blockage or backlash,
is measured and then leads to the
machine being switched off
Feed rate too fast
Blunt saw blade
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
The saw blade used is unsuitable
for the task or blunt
Wood is too damp
Extended operation without extrac-
tion
ENGLISH
Solution
Charge the rechargeable
battery
Allow rechargeable battery to
engage completely
Check, press button 11. Fig. 1
+ 7 + B
Only one LED is still glowing.
Charge the rechargeable
battery.
Allow the machine and the
rechargeable battery to cool
down.
The rechargeable battery can
be cooled down much faster
with a charger with air cooling.
The machine can also be
cooled down much faster by
using a different rechargeable
battery and idling the machine.
Switch off the machine by
releasing the switch trigger.
Afterwards, you can switch the
machine back on again and
resume work as normal.
Try to avoid further blockages
Reduce feed speed
Release the switch immediate-
ly. Remove the machine from
the workpiece and replace the
saw blade
Use parallel stop
Straighten the surface
Replace saw blade
Connect to an external extrac-
tion, e.g. portable dust extrac-
tor
31