Decommissioning And Removal; Spare Parts - Wilo FireSet UL FM Einbau- Und Betriebsanleitung

11 Decommissioning and removal

If the Wilo-FireSet must be decommissioned, first
disconnect the unit from the power supply and
water circuit, and then separate the different
materials of the unit to eliminate them separately.
Assign a company that is in charge for the removal
of industrial machinery.
Check that there are no residues of any polluting
liquids inside the pump and pipes.
The unit equipped with diesel motor may have
batteries, which contain lead and electrolytic liq -
uid including acids, solutions of water and anti -
freeze liquid, oil and fuel.
Pay particular attention to the elimination of bat -
teries and make all necessary actions to prevent
any spillage of liquid on the ground that can pol -
lute the environment.
If materials of the unit are spread in the environ -
ment, they can create serious environmental
damages.
NOTICE
Disposal in domestic waste is forbidden!
In the European Union, this symbol can appear on
the product, the packaging or the accompanying
documentation. It means that the electrical and
electronic products in question must not be dis-
posed of along with domestic waste.
All materials and components must be collected,
and eliminated in accordance with the regulations
in force. Even during the installation operations
and handling, the following materials must be sent
to centres specialized in the collection and
removal of waste:
• Electromechanical and electronic components
• Electric cables
• Batteries
• Strainers
• Oil drain
• Mix of water and antifreeze
• Rags and smooth material used for various opera -
tions or cleaning
• Materials for packaging
Liquids and polluting materials must be eliminated
according to the specific standards in force.
Make a separated elimination allows to retrieve
equipment, and to reduce pollution.
To ensure proper handling, recycling and disposal
of the used products in question, notice the fol -
lowing points:
• Only hand over these products at designated, cer -
tified collecting points.
• Observe the locally applicable regulations!
Installation and operating instructions Wilo-FireSet UL FM
Consult your local municipality, the nearest waste
disposal site, or the dealer who sold the product to
you for information on proper disposal.
For further information on recycling, go to
www.wilo-recycling.com.

12 Spare parts

For rapid intervention and recovery of the Wilo-
FireSet and according to the type of pumping con -
ditions, it is advisable having a minimum amount
of spare parts in stock, according the recommen -
dation in the operating manual of the single main
components (pump, drive, coupling, switchgear),
for example:
Main electric pump
Complete seal, protection fuses, starting pressure
switch, step relay coil.
Main diesel pump
Complete seal, protection fuses, starter kit, oil
heater, starting pressure switch, two fuel strain -
ers, two oil strainers, two sets of straps, two injec -
tor nozzles for the diesel motor, a complete kit of
connections, gear and oil and fuel circuit hoses,
tools recommended by the manufacturer of the
diesel motor.
Electric jockey pump
Complete mechanical seal, protection fuses, and
starting pressure switch.
English
21