Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Interim Storage; Shipping - Wilo BAC Einbau- Und Betriebsanleitung

English
2.7 Unauthorised modification and
manufacture of spare parts
2.8

Improper use

3

Transport and interim storage

3.1

Shipping

Transport inspection
Storage
Handling
3.2 Transport for installation/removal
purposes
4

Intended use

Purpose
Fields of application
20
Immediately on conclusion of the work, all safety and protective
devices must be put back in position and/or recommissioned.
Unauthorised modification and manufacture of spare parts will put
the safety of the product/personnel at risk and invalidate the state-
ments on safety made by the manufacturer.
Modifications to the product are only permissible after consultation
with the manufacturer. Original spare parts and accessories author-
ised by the manufacturer ensure safety. The use of other parts can
nullify the liability from the results of the usage.
The operating safety of the supplied product is only guaranteed when
used properly in accordance with the section in the operating instruc-
tions titled "Intended use". The limit values must on no account fall
under or exceed those specified in the catalogue/data sheet.
The pump is delivered from the factory packaged in a cardboard box
or secured to a pallet and protected against dust and moisture.
On arrival, inspect the pump immediately for any transport damage. If
damage is found, the necessary procedure involving the forwarding
agent must be taken within the specified period.
Before installation, the pump must be kept dry, frost-free and pro-
tected from mechanical damage.
CAUTION! Risk of damage due to incorrect packaging!
If the pump is transported again at a later time, it must be packaged
so that it cannot be damaged during transport.
• Use the original packaging for this, or select equivalent packaging
Handle the pump with care to avoid any damage of the product before
installing it.
WARNING! Risk of personal injury!
Improper transport can lead to personal injury.
• The pump must be transported using approved load-bearing
equipment (e.g. block and tackle, crane, etc.). This must be secured
to the pump flanges and, if necessary, to the external diameter of
the motor (protection against slipping is required!).
• Never stand underneath a suspended load.
• Make sure the pump is securely positioned and is stable during
storage and transport as well as prior to all installation and other
assembly work.
BAC pumps are single-stage centrifugal pumps that are used for fluid
circulation in buildings, agriculture and industry.
They may be used for:
• Cooling systems
• Cold and hot water systems
• Industrial water systems
• Industrial circulation systems
WILO SE 11/2013