Suction And Metering Line Connection With Tapered Part; Electrical Connection; Power Supply - ECOLAB Elados EMP IV E60 serie Betriebsanleitung

7.1.2.3

Suction and metering line connection with tapered part

NOTE
This type of connection is available only for 1¼"-valves.
7.2

Electrical connection

7.2.1

Power supply

Fig. 7.14 Power supply
Terminal box – internal view, 1-phase motor
* IEC 757 colour coding
WARNING
The mains voltage has to correspond with the value indicated on the nameplate.
The metering pump is provided with an installed thermic winding protector, which stops
NOTE
the motor when overheated.
417101799_EMP_IV_E60.docx
Pos. Description
1 Hose
2 Union nut
3 Clamping piece
4
Tapered part
5 O-ring
 Cut off hose cleanly.
 Push union nut and clamping piece over hose.
 Push hose onto connection nipple as far as tapered part
 Move clamping piece into direction of tapered part until you feel resistance.
 Place O-ring into groove of suction/pressure valve.
Tighten up union nut.

Fig. 7.13 Suction and metering line connection with tapered part
Power connection should be produced
according to the current CE guidelines.
Furthermore, the specific regulations, which
were enforced in every single country, as well
as all regulations established by local electric
supply companies have to be observed.
In Fig. 7.14 you can see the connecting plan
for a one-phase-motor.
In addition to that, you will find all connection
plans on the cover of the motor's terminal box.
Pos. Description
1 Powerline
2 Main to pump housing
Connection start-up
3
(in terminal box cover)
- 81 -
electronics*
Rev. 11-10.19