Setup; Indicators / Controls / Jacks - ECOLAB Elados EMP IV E60 serie Betriebsanleitung

5

Setup

The external structure and the displays, control elements and connecting sockets on the
EMP IV E60
NOTE
The difference between this models can be found in the PCB configuration, which can be
upgraded to the
Fig. 5.1 EMP IV E60 (Front)
5.1

Indicators / Controls / Jacks

417101799_EMP_IV_E60.docx
and the EMP IV E60 are identical.
PLUS
"E60 (see chapter
PLUS
Fig. 5.2 EMP IV E60 (side view)
Fig. 5.3
- 76 -
8 "Upgrading the EMPIV E60 to the EMPIV E60
Pos. Designation
1
2
3
4
5
6
7
8
9
10
Pos. Designation
1 Fault-LED
2 Graphical display
3 Menu/Exit, up arrow key
4 Menu/Exit, down arrow key
5 Start/Stop key (Enter function)
6
Test key
Cable entry point for any desired connection
7
8 On-Off switch
9 Cable entry point for Level alarm output
Cable entry point for Pulse / current input and
10
metering disable system
Input for low-level advance warning and empty
report (see 7.2.4.1
Slot I (3-terminal) input for low-level advance
11
warning and empty report" &
assignments: low-level advance warning
(3 terminal)").
Indicators / Controls / Jacks
PLUS
Electrical motor connection
Motor
Oil filler opening with
overpressure cap
Control knob for setting the
stroke length
Oil-level gauge glass
Pump head
Pressure valve
Suction valve
Waste oil screw
Connection for diaphragm
sensor / diaphragm
breakage drain
Flow direction of the
metering medium
"Connector assignments of
14.5.1 "Connector
Rev. 11-10.19
").