Selecting; Configuration / Metering Controller; Plus & Ogm Plus - ECOLAB Elados EMP IV E60 serie Betriebsanleitung

10.3.11.1 Selecting

10.3.12 Configuration / Metering controller (only E60
Fig. 10.28 Configuration / Metering controller
If an OGM Plus is connected, when the metering controller function is activated, the dosage
quantity measured by the OGM is compared with a pre-defined dosage quantity target
value. If there is a discrepancy between the values, the metering frequency of the pump is
automatically increased or decreased.
Since metering frequency can only be adjusted within the performance limitations of the
pump, setting the dosage quantities higher than 80 or 90% of the maximum possible
metering frequency is not recommended. This will ensure that the metering controller retains
sufficient reserves to react to negative control deviations.
The metering controller function can only be used in the 'internal' and 'current' operating
modes. If the operating mode 'pulse' is selected, the metering controller function will not
work.
NOTE
10.3.12.1 Selecting
417101799_EMP_IV_E60.docx
The metering controller function can only be activated if the pump is upgraded with a
dongle plate to the E60 PLUS
connected.
To activate the dongle plate in connection with the oval gear meter, the power supply has
to be switched off and on again!
Fig. 10.27 Configuration / OGM / selecting
& OGM
PLUS
and oval gear meter , type OGM
Fig. 10.29 Configuration / metering controller / selecting
- 102 -
- oval gear meter is inactive.
(Default setting)
oval gear meter is active.
✓
)
PLUS
PLUS (see accessories) is
- controller function is inactive.
(Default setting)
controller function is active.
✓
Rev. 11-10.19