Installation Diaphragm Burst Detector; Installation Metering Monitoring; Connector Assignments Terminal X3; Installation Low-Level Warning And Fault - ECOLAB Elados EMP IV E60 serie Betriebsanleitung

7.2.5.1

Installation diaphragm burst detector

7.2.5.2

Installation metering monitoring

The metering monitoring function must be activated in menue first.
NOTE
(see chapter:
7.2.6

Connector Assignments Terminal X3

Fig. 7.29 Terminal X3
7.2.6.1

Installation low-level warning and fault

Fig. 7.30
417101799_EMP_IV_E60.docx
13+14+15+16
Terminal
Fig. 7.27
10.3.13 "Configuration / Metering monitoring")
Terminal Description
1
Out put low-level advance warning, empty report, fault report
2
= Input diaphragm burst detector
Conductor
coloring
Assignment
(cable
connection)
Anode
13 brown
(for sensor with anode connection)
14 white Output 5V DC
15
blue Relay input diaphragm burst signal
GND ( ┴ )
16 schwarz
Installation diaphragm burst detector
20 +
monitoring with potential-free
contact
Terminal Assignment
20
21
19 +
monitoring function with electronic
switch
Terminal Assignment
19
20
21
Fig. 7.28
1 + 2 = Output low-level warning, empty
report and fault
Input low-level warning active:
relay output connected
Input low-level warning active acc. fault
container active:
relay output closed
(function invertible see chapter
"Configuration / Alarm output" and
chapter 7.2.6.2 "Hardware migration for alarm
contact"),
relay output = potential-free relay contact,
load 24 V AC/DC 3 A ecc. 115/230V 3A
Fig. 7.30 Installation low-level warning and fault
- 86 -
21 = Input metering
Relay input
GND ( ┴ )
20 + 21 = Input metering
Output 5V DC
Relay input
GND ( ┴ )
Installation metering monitoring
10.3.9
Rev. 11-10.19