Software Version Display; Display At Operating Level; Configuration - ECOLAB Elados EMP IV E60 serie Betriebsanleitung

9.5.1

Software version display

Fig. 9.8 Software version 1
Fig. 9.9 Software version 2
9.5.2

Display at operating level

In "as-supplied condition", the following default basic settings appear on the display
after switching on the pump (main switch on "I").
Fig. 9.10 Display /internal
NOTE
With each stroke of the pump, the indicator in the upper right of the display
9.5.3

Configuration

The following factory settings are defined in the configuration.
Fig. 9.11 Configuration
417101799_EMP_IV_E60.docx
The current software version (pos. 1) is displayed in the top right
of the main menu screen.
Lowercase letters after the software number (pos. 2) describe
internal software modifications that do not affect the operation of
the device.
If a dongle plate has been connected, the unit version (pos. 3) is
displayed to the right of the pump version.
Operating mode:
Metering frequency / - quantity: strokes/min
Operating state:
Configuration of
language:
unit:
code:
auto start:
metering lock:
low level contact:
alarm output:
pulse memory:
oval gear meter:
metering controler:
meter monitor:
batch:
- 91 -
internal
(122 strokes/min at 50 Hz,
146 strokes/min at 60 Hz)
OFF (in V 3.6, „Standby" in V 3.5
(to start press START / STOP key)
Standard
german
liter
not active (-)
not active (-)
not active (-)
open ()
off (⚫)
not active (-)
not active (-)
not active (-)
not active (-)
not active (-)
rotates 1 turn.
see chapter
10.3.3
10.3.4
10.3.5
10.3.6
10.3.7
10.3.8
10.3.9
10.3.10
10.3.11
10.3.12
10.3.13
10.3.14
Rev. 11-10.19