Display In The Operating Display/ Setting; Operation Mode / Pulse - ECOLAB Elados EMP IV E60 serie Betriebsanleitung

10.2.2.2

Display in the operating display/ Setting

The metering rate can be configured/adjusted in the operating display during operations.
If the newly set value is not confirmed within 10 seconds by pressing the START/STOP
NOTE
key, the system reverts to the primarily value.
Fig. 10.4 Strokes/min
Fig. 10.5 Percent (%)
Fig. 10.6 Liter/min
10.2.3

Operation mode / pulse

For the "pulse" operation mode, the metering pump only works in conjunction with incoming
pulses (e.g. from a contact water meter).
The following pulse processing options can be selected:
•
Multiplication
•
Division
417101799_EMP_IV_E60.docx
Strokes/min
Percent (%)
Liter/min
Incoming pulses are multiplied by a configurable factor (n):
1 pulse = n pump strokes (default setting)
Incoming pulses are divided by a configurable factor (n):
n pulse = 1 Pumpenstroke
Gallons/day
Fig. 10.4 Gallons/day
- 94 - Rev. 11-10.19