Inspection Every 250 Hours Or 3 Months - Takeuchi TB 175 Handbuch

2. Inspection and adjustment

2.2.4 Inspection every 250 hours or 3 months

Be sure to check the following points every 250 hours or 3 months operation, whichever comes first.
No.
(1) Lube oil and filter replacement
(2) Radiator fin cleaning
(3) V-belt tension check
(4) Inspection and adjustment of governor lever and accelerator
(5) Air cleaner cleaning and element replacement
(1) Lube oil and filter replacement (The second replacement and after)
Replace the engine oil every 250 hours operation from 2nd time and on. Replace the engine oil filter at the
same time. Refer to 2.2.1.(1).
(2) Radiator fin cleaning
Dirt and dust adhering on the radiator fins reduce the
cooling performance, causing overheating. Make it a
rule to check the radiator fins daily and clean as
needed.
• Blow off dirt and dust from fins and periphery with
compressed air [0.19MPa (2 kgf/cm
damage the fins with compressed air.
• If contaminated heavily, apply detergent, thoroughly
clean and rinse with tap water shower.
IMPORTANT:
Never use high pressure water or air from close by
fins or never attempt to clean using a wire brush.
Radiator fins can be damaged.
(3) V-belt tension check (The second time and after)
Check and adjust the V-belt tension. Refer to 2.2.2(2)
Inspection Item
Beware of dirt from air blowing
Wear protective equipment such as goggles to protect your eyes when
blowing compressed air. Dust or flying debris can hurt eyes.
2
) or less] not to
32
Dust, dirt
Radiator fins
Air blow