Takeuchi TB 175 Handbuch Seite 739

2. Inspection and adjustment
In early period of use, the engine oil gets dirty rapidly
because of the initial wear of internal parts. Replace the
engine oil earlier.
Lube oil filter should also be replaced when the engine
oil is replaced.
The procedure of lube oil and lube oil filter replacement
is as follows.
(a)Drain engine oil
• Prepare a waste oil container collecting waste oil.
• Remove the oil filler cap to drain easily while draining
the lube oil.
• Loosen the drain plug using a wrench (customer pro-
cured) to drain the lube oil.
• Securely tighten the drain plug after draining the lube
oil.
[NOTICE]
Use a socket wrench or a closed wrench when
removing or tightening a drain plug.
Don't use a spanner because it has the possibility
that the spanner will slip and it will get hurt.
(b)Replacing oil filter
• Turn the lube oil filter counter-clockwise using a filter
wrench (customer procured) to remove it.
• Clean the mounting face of the oil filter.
• Moisten the new oil filter gasket with the engine oil
and install the new engine oil filter manually turning it
clockwise until it comes into contact with the mount-
ing surface, and tighten it further to 3/4 of a turn with
the filter wrench.
Tightening torque: 20 to 24 N•m (2.0 to 2.4 kgf•m)
Model
3TNV82A to 4TNV98 (T)
4TNV106 (T)
(c)Filling oil and inspection
• Fill with new engine oil until it reaches the specified
level.
IMPORTANT:
Do not overfill the oil pan with engine oil.
Be sure to keep the specified level between upper
and lower limit on the dipstick.
• Warm up the engine by running for 5 minutes while
checking any oil leakage
• Stop the engine after warming up and leave it stop-
ping for about 10 minute to recheck the engine oil
level with dipstick and replenish the engine oil. If any
oil is spilled, wipe it away with a clean cloth.
Applicable oil filter Part No.
129150-35151
119005-35100
The location depends on the engine
installed on the machine unit
26
Dipstick
Oil pan
Drain plug
Engine oil filter