Cylinder Head: Disassembly, Inspection And Reassembly; Components (2-Valve Cylinder Head); Disassembly Procedure - Takeuchi TB 175 Handbuch

4. Disassembly, inspection and reassembly of engines

4.2 Cylinder head: Disassembly, inspection and reassembly

4.2.1 Components (2-valve cylinder head)

Fuel injection pipe
Fuel filter
Oil/water separator

4.2.2 Disassembly procedure:

Disassemble in the order of the numbers shown in the illustration.
1)Remove the alternator assy. (Point1)
2)Remove the fan, pulley and V belt.
3)Remove the thermostat case. (Point2)
4)Remove the fuel filter and fuel oil piping. (Point3)
5)Remove the oil level gage assy.
6)Remove the oil filter. (Point4)
7)Remove the fuel injection pipes. (Point5)
8)Remove the intake manifold assy.
9)Remove the exhaust manifold assy.
10)Remove the rocker arm cover assy.
11)Remove the rocker shaft assy, push rods and valve caps. (Point6)
12)Remove the cylinder head assy and head gasket. (Point7)
13)Remove the fuel injection valves and fuel return pipe. (Point8)
14)Remove the intake/exhaust valves, stem seals and valve springs. (Point9)
15)Remove the rocker arms from the rocker shaft.
Rocker arm cover
Intake maniforld
Head gasket
Cylinder block
Gear case
Oil filter
Exhaust manifold
Cylinder head
Joint
Thermo switch
V-pulley
Spacer
Note) This figure shows the 3TNV84.
70
Oil cooler
Thermostat
Cooling water pump
Fan