Takeuchi TB 175 Handbuch Seite 954

Position the camshaft key groove as shown in the
illustration.
Engagement of gears
・ With the phase of camshaft and collar of transmission shaft set in the direction as shown below, engage gears
A and B with each other. (Check that the match mark of gear B and the mark of gear A shown below are
aligned with each other by looking through the feed pump installation hole.)
・ When inserting the stopper pin, do not raise the transmission shaft excessively, or the gears will be
disengaged. (Check the engagement again after inserting the stopper pin.)
・ The positions of the collars of transmission shaft are not limited only if either one is at the top or bottom as
shown.
Install the removal stop, (transmission shaft).
Fasten the removal stop, (transmission shaft).
Tightening Torque : 8-10 N-m
32