Re-Assembling The Governor - Takeuchi TB 175 Handbuch

3.4. Re-assembling the Governor

Governor Body Parts
Governor Lever CMP End Float Adjust Shim
Pierce the governor lever CMP and shim through the governor
lever shaft and assemble.
Measure the side clearance of the tension lever with
thickness gauge.
Standard: 0.3 to 0.6 mm (adjusting with shim)
Fit the governor lever shaft with the removal stop, (governor
lever shaft) and fasten the removal stop bolt.
Install the shim to the shaft, (control lever).
Install the regulator lever.
Pierce the spring, (control lever) through the lock nut, (control
lever) and fasten it to the thread of the shaft, (control lever).
Fasten the nut, (control lever).
Tightening Torque : 19.6-24.5 N-m
Measure the side clearance with thickness gauge.
Standard: 0.3 to 0.6 mm (adjusting with shim)
39