Takeuchi TB 175 Handbuch Seite 706

(2) How to Read the Explanations
• An exploded view, sectional views, a system diagram, etc. are shown at the beginning of each section as
required for easy understanding of the mounted states of the components.
• For the removal/installation of each part, the procedure is shown with the procedural step No. in the illus-
tration.
• Precautions and key points for disassembly and reassembly of parts are described as points. In the expla-
nation for each point, detailed operation method, information, standard and precautions are described.
Flywheel
Fuel pump spacer
Fuel injection pump
Don't disassemble!
The job contents are described in the disassembly procedure for Nos. not shown in the illustration.
• Disassembly procedure
1)Follow steps (1) to (15) of the cylinder head disassembly procedure.
2)Remove the cooling water pump.
3)Remove the crankshaft pulley. (Point 1)
• Operation points
Disassemble: Service point for removal
Reassemble: Service point for installation
Disassemble-Reassemble: Service point required in both removal and installation.
Description Example
Flywheel housing
Starter
Idle gear
Pump flange
Fuel pump drive gear
Flange bolt
Operation point to be explained on a later page.
Gear case flange
Camshaft
Cooling water pump
Crankshaft
gear
Gear case
Note) This figure shows the 3TNV84.
Camshaft driving gear
Oil seal
Crankshaft pulley