Takeuchi TB 175 Handbuch Seite 955

Install the tappet.
Direct the tappet's whirl-stop groove as shown in the
illustration.
Assembling tappets
Insert tappet into the pump body with the slit
directed toward the lock side, and attach the
tappet lock. (T = 4 to 5 N
Turn the camshaft to check that the tappet
moves up and down smoothly.
Install the whirl-stop, (tappet).
Tighten the tappet, while moving it upward and
downward.
Install the governor weight CMP and nut, (governor support).
Whirl-stop groove
m)
•
Fasten the nut, (governor support), (and provide the whirl-stop
to the cam shaft.)
Tightening Torque : 79 - 84 N-m
Install the feed pump.
Identification hole (φ3, depth 2 mm)
Note that the identification hole can be seen only when
looking from obliquely above because it is located on the
pump case side.
33
Identification of feed pump
Spec.
φ3 identification
hole
General Not provided
purpose
TK Provided