Takeuchi TB 175 Handbuch Seite 870

9. Starting motror
(3) Pinion projection length
Connect the positive (+) lead from the battery to terminal
S and negative (-) lead to terminal M. Turn the switch
ON and measure the pinion moving distance L in the
thrust direction.
Perform this test within 10 seconds.
mm
Standard
L 0.31.5
Note: Before measuring the dimension, pull the
pinion out lightly in the direction of the arrow.
If the measured L dimension is outside the standard
range, either insert or remove the dust cover (adjusting
shim 0.5 mm, 0.8 mm) for adjustment.
154
S
M
l
0.3 1.5mm
Fig. 29
Dust cover
(adjusting shim:
0.5mm, 0.8mm)
Fig. 30