4.3 Gear train and camshaft
4.3.1 Components
Flywheel
Fuel pump spacer
Fuel injection pump
Don't disassemble!
4.3.2 Disassembly procedure:
Disassemble in the order of the numbers in the illustration.
1)Perform steps 1) to 12) of the cylinder head disassembly procedure.
2)Remove the cooling water pump.
3)Remove the crankshaft pulley. (See Point 1 of 4.3.4)
4)Remove the gear case cover. (See Point 2 of 4.3.4)
5)Remove the fuel injection pump. (See Point 3 of 4.3.4)
6)Remove the idle gear assy. (See Point 4 of 4.3.4)
7)Remove the PTO drive gear. (See Point 5 of 4.3.4)
8)Remove the starting motor.
9)Remove the flywheel. (See Point 6 of 4.3.4)
10) Remove the camshaft assy. (See Point 7 of 4.3.4)
11) Remove the gear case. (See Point 8 of 4.3.4)
12) Remove the oil seal from the gear case cover. (See 4.3.6)
4.3.3 Reassembly procedure:
Reverse of the disassembly procedure.
4. Disassembly, inspection and reassembly of engines
Flywheel housing
Starter
Idle gear
Pump flange
Fuel pump drive gear
Flange bolt
83
Gear case flange
Camshaft
Cooling water pump
Crankshaft
gear
Gear case
Oil seal
Crankshaft pulley
Note) This figure shows the 3TNV84.
Camshaft driving gear