Takeuchi TB 175 Handbuch Seite 953

Attaching camshaft
Apply molybdenum disulfide to the bushing or the
bearing.
Insert the camshaft into the pump body with
transmission shaft CMP at the lowered position
(gear B touching the pump body).
Be careful that the cam and gear B do not interfere
with each other.
(Especially for 4 cylinder engine, note that the
phase in which the cam passes is limited.)
The shaft can be inserted with the key of the
driving side press-fitted to the camshaft.
Be careful not to damage the camshaft bushing.
Install the camshaft.
Tightening Torque : 8-10 N-m
Checking backlash
Rotate camshaft to check that transmission shaft
rotates smoothly.
Fix transmission shaft from upper surface of the
housing, and turn the camshaft to check the backlash.
Backlash must be in the range from 0.2 to 1.5 degree.
Note: When measuring at the position of camshaft
driving side key (at the center of the key as shown below),
the displacement must be in the range from 0.03 to 0.25.
Position the transmission shoe of the
transmission shaft CMP as shown in the
illustration.
31
Rack plug
Tighten the rack plug. (If rack
plug has been removed.)
Tightening Torque : 79-84 N-m