Takeuchi TB 175 Handbuch Seite 746

(4) Inspection and adjustment of governor lever and accelerator
The governor lever
(accelerating lever, pedal, etc.) of the machine unit are
connected by an accelerating wire or rod. If the wire
becomes stretched or the connections loose, the
deviation in the position may result and make operation
unsafe. Check the wire periodically and adjust if
necessary.
Do not strongly move the accelerating wire or
accelerating pedal. It may deform the governor lever or
stretch the wire to cause irregular engine speed control.
Checking and adjusting procedure are as follows.
1)Check that the governor lever of the engine makes
uniform contact with the high idling and low idling
limiting bolt when the accelerating devices is in the
high idling speed or low idling speed position.
2)If either the high or the low idling speed side does
not make contact with the limiting bolt, adjust the
accelerating wire.
Loosen the accelerating wire fixing nut and adjust
the wire to contact with the limiting bolt.
Never release the limiting bolts. It will impair the safety and performance of the product and functions and
result in shorter engine life.
(5) Air cleaner cleaning and element replacement
The engine performance is adversely affected when the
air cleaner element is clogged by dust. So periodical
cleaning after disassembly is needed.
1)Undo the clamps on the dust pan and remove the
dust pan.
2)Loosen the wing bolt on the element and pull out the
element.
and accelerating devices
Beware of dirt from air blowing
Wear protective equipment such as goggles to protect your eyes when
blowing compressed air. Dust or flying debris can hurt eyes.
High
High idle
limiting bolt
MP2 Fuel Injection pump
OPTION
33
2. Inspection and adjustment
Low idle
limiting bolt
Govenor lever
Low
Accelerating
wire bracket
Accelerating wire fixing nut
Accelerating wire bracket
Air cleaner case
Arrow mark
Element
Air blow
Dust pan
latch
Arrow
mark