Assembly - Takeuchi TB 175 Handbuch

9.1.7 Assembly

The assembly procedure is the reverse of the
disassembly procedure, but pay attention to the
following points:
(1) Grease application points
• Gears in the gear case
• Shift lever operating portion
• Pinion sliding portion
• Magnetic switch plunger sliding portion
Use the specified grease as below table at all points.
Pinion and magnetic switch plunger sliding portions
Gears
Shift lever operating portion
(2) Magnetic switch assembly
1)Install the shift lever on the magnetic switch with the
torsion spring in-between.
2)For installation on the gear case, install the magnetic
switch with the shift lever on the gear case after pull-
ing the pinion out. Fix the magnetic switch by tight-
ening a built-in bolt M6. Do not forget to install the
dust cover (adjusting shim).
NPCFG-6A
MALTEMP SRL
ALBANIA No.1
153
9. Starting motror
Fig. 27
Fig. 28