Takeuchi TB 175 Handbuch Seite 934

(2) Starting control
Moving the control lever to the max． speed position pulls the governor spring, and moves the tension lever until it comes in
contact with the control stopper.
When this is done，the excess fuel spring provided in between the tension lever and governor lever holds the control rack
at the maximum starting injection volume position R
After the engine is started, the excess fuel spring is compressed when the centrifugal force of the governor weight
overcomes the set of the excess fuel spring as speed exceeds N
spring ) or B to C(on models without angleich spring ). The rack reaches the position of R
tension lever are interlocked.
（3） Idling
When the control lever is returned to the idling position after the engine is started. the governor spring tension decreases
and the tension lever descends clockwise, and the governor weight load keeps the governor spring and the excess fuel
spring load in equilibrium to maintain idling speed at (R
.
A-B
, speed goes from B to C' (on models with angleich
b
).
L
12
where the governor lever and
c