Adjustment Of Reverse Angleich - Takeuchi TB 175 Handbuch

4.3.4. Adjustment of Reverse Angleich

In the case of the governor with reverse angleich mechanism, use the reverse angleich spring
in the assembled state.
Adjustment of Reverse Angleich
Make adjustment of reverse angleich after completing the following processes:
Adjustment of fuel volume limiter bolt
●
Adjustment of no-load max, and min. revolutions limiter bolt
●
① Shift the control lever to the full load position, and maintain the fuel injection pump revolution to the
specified reverse angleich control revolution number (N
② In this condition, remove the governor rear cover, and screw the reverse angleich assembly into
the threaded portion of the tension lever until it hits the reverse angleich lever. If screwing it in
additionally, the reverse angleich lever will shift in the direction of fuel reduction. Screw and set it to
the position of the specified injection quantity (R
③ Tighten the lock nut with specified tightening torque, and attach the governor rear cover.
Lock Nut Tightening Torque
④ Again, increase the revolution of the fuel injection pump to the rated revolution speed (N
that the control rack will change the position of the reverse angleich stroke smoothly, and confirm
that the rack position (R
24.5-29.4(2.5-3.0)
) and injection volume are within the specified limits.
1
).
6
).
6
N-m (kgf-m)
47
), check
1