Assembling The Hydraulic Head - Takeuchi TB 175 Handbuch

Measure the plunger top position.
Bottle clearance adjustment should refer to Page 59.

3.3.4. Assembling the Hydraulic Head

Install the accumulator.
Attaching accumulator
Be sure to install the piston in the correct
direction.
Make sure that the piston can slide smoothly.
Install the spring, (accumulator).
Install the plug with new seal washer, (accumulator).
Install the distribution shaft.
Inserting distribution shaft
・ Insert distribution shaft so that the directional
relationship between the shaft and camshaft is as
shown below (Do not assemble upside down).
・ Use the following drawing simply as a reference
because the component can be inserted in either of
two orientations.
・ Insert the component securely into the distribution
shaft joint until it is sunk below the end surface of
the distribution shaft sleeve.
Direction of fixed flange (camshaft keyway)
(As viewed from driving side)
Camshaft keyway
Flange cutout
Direction of distribution shaft longitudinal
groove
(As viewed from upper side
Distribution shaft longitudinal groove,
cut off surface
Governor side
Driving side
35
Upper side
Lower side