Takeuchi TB 175 Handbuch Seite 747

2. Inspection and adjustment
3)Blow air [0.29 to 0.49 MPa (3.0 to 5.0 kgf/cm
inside the element to blow dust off as shown in the
illustration right.
Apply the air blowing pressure as low as possible so
as not to damage the element.
If having the air cleaner with double elements, never
remove and clean the inner element.
The aim of installing the inner element is for back up
protecting from intaking dust during engine running
when leaving the outer element to reinstall after
removing it or when damaging the outer element
unexpectedly during engine running.
4)Replace the element with new one, If the element is
damaged, excessively dirty or oily.
5)Remove the inside dust cover of the dust pan, and
clean inside of the dust pan.
6)Reinstall the element with the wing bolt. (do not
leave the gasket.) Reattach the inside dust cover to
the dust pan and install the dust pan to the air
cleaner case placing the TOP mark upward.
IMPORTANT:
• When the engine is operated in dusty conditions,
clean the element more frequently.
• Do not run the engine with removed air cleaner or
element, as this may cause foreign material to enter
and damage the engine.
2
)] from
Dust indicator (optional)
OPTION
34
Air cleaner case
Arrow mark
Inner element
Outer element
latch
Double elements type air cleaner
with inner and outer element
Arrow
mark
Dust pan