Bosch BSA 250 Betriebsanleitung Seite 47

11.3 Abridged report
Prerequisite: Measurement data for FA and RA are available.
Press D button (F11), followed by 1 and E (F17),
The axle weight and axle deceleration are only printed out when
the weighing device special accessory is used. If the weight is
entered by hand, the additional words „permissible gross vehicle
weight" are also printed out. The pedal force is only printed out
when the pedal-force sensor special accessory is used.
i
As of Firmware version 1.6, dated 03-21-02 you have the
option to select in menu 27 whether or not you wish to
have the time when the test was performed included in this
printout.
1 689 979 689 22.01.03
11.4 Report of brake force progression by pedal force or
time, tabular
Press D button (F11), followed by 2 and E (F17),
i If the pedal dynamometer has been connected up, the
printout is based on force applied to the pedal and not time.
The brake difference is not included on the printout unless the
brake force is at least 500 N.
The brake force progression during the interval while out-of-
roundness is being measured is not shown on the printout.
47