Werbung
Verfügbare Sprachen
Verfügbare Sprachen
End of test:
– Enter the gross vehicle weight.
1
2
Once the test has been performed, you have to enter the gross
vehicle weight to enable the braking ratio to be calculated (see
section 9.1).
If the test bench is equipped with scales, the weights measured
by them are used to calculate the braking ratio. If you want to use
the gross vehicle weight for this calculation, you have to overwrite
the measured value. To do this, press the G button (F9) on the
remote-control unit and then enter the new value using the
numeric keys.
– Display of gross vehicle weight and braking ratios.
1
2
b.
5
F.
2
The above displays can be called up at the end of the test when
the test bench is in its idle state (vehicle no longer on roller set and
Automatic mode „off"). Press the U button (F13) on the remote-
control unit repeatedly to display the gross vehicle weight and the
various maximum braking ratios one after the other.
i The braking ratio values flash if the legally required values are
not complied with. If no value can be displayed due to a lack
of data, dashes appear instead of digits.
The values remain on display until a new measurement is taken or
you delete the measured values by pressing the 2nd button (F 14)
and then the CA button (F16).
44
3
0
3
0
0
"i
9
"i
Further displays:
– Print
P
1
Displays which report form is printed out.
This remains displayed until printout is completed.
– Confirmation of the remote-control commands
8.
8 .
8 .
Flashes briefly when you make an entry using the remote-control
unit.
– Error messages
E
1
0
The appropriate error code is displayed when an error occurs.
8.
8.
1
6
22.01.03
1 689 979 689
Werbung
