Settings; Audio; Network; Printer Setup - Actim 1ngeni Bedienungsanleitung

11

SETTINGS

The "Settings" screen is accessed from the home menu and allows a user
to configure the Actim 1ngeni instrument. The different settings can be viewed
using the arrow icons.

3.1 Audio

The volume can be adjusted from 0 (no sound) to 5 (highest volume) at the audio
screen. The default volume is 3. It is possible to listen to the chosen sound by
pressing the word "Test".
The instrument uses sound for the following functions:
• Touch tone: A screen "click" whenever the touch screen is used
• Tones: Process tones for end of test, alerts and warnings

3.2 Network

The "Network Setup" screen allows a user to configure the Ethernet connection
of the instrument.
Supported functions include:
Selecting between DHCP and Static Network
Entering IP address
Entering Subnet Mask
The default is DHCP. Switching to Static IP, IP Address and a Subnet Mask must be entered manually.
DHCP (Router): The Actim 1ngeni instrument supports the use of a typical network with DHCP enabled. Plug the
instrument into a network port on the router, then power the instrument on.

3.3 Printer setup

The following printer settings can be modified:
• Select Auto Print.
• Select Network Printer.
• Enter IP Address.
The default is to connect to an attached USB printer.
If "Network Printer" is selected, then the user can specify the IP address of the printer to connect. Disconnect the
USB printer prior to using the network printer.