Accessories; Printer; Usb Key - Actim 1ngeni Bedienungsanleitung

29

ACCESSORIES

Accessories that can be used with the Actim 1ngeni instrument are available separately and include a:

• USB key

• Label printer, the Seiko SPL620
• Barcode scanner, the Datalogic QuickScan Barcode Wand QD2430
In addition to these, it is possible to use a network printer and an external battery (see
Sections 9.4 and 9.5 for more information).
Two ferrite cores are supplied with the Actim 1ngeni instrument. The ferrite must be fit
into the following accessories prior to the use of the instrument:
Place the USB peripheral cable inside the ferrite core; the distance from the ferrite core
to the USB connector base should be 29±2mm
Lock the cable into place by pushing the cable down.
Close the ferrite core once the cable is in the correct position.

9.1 Printer

Seiko Smart Label Printer – SLP 620
The Seiko Smart Label printer type SLP 620 is approved for operation with the Actim
1ngeni instrument. The printer will print the test report onto a label.
Operation Summary:
Plug the SLP 620 AC Adapter cord into the mains outlet.
Connect the output cord to the instrument and power up.
Connect the SLP USB cord to the instrument.
Turn on SLP by pressing the power button. Ensure that the green status light
is shown, indicating that the printer is online. Press the button once to toggle
between online and offline modes.
Prepare and load a roll of labels into the spindle holder under the label cover and
adjust the label guide to fit the labels.
Insert free end of the roll into the slot until the SLP automatically feeds the labels
through. If this doesn't occur, press the form feed button to advance the labels
through the slot. Close the label cover.
With the SLP turned on, run the test on the Actim 1ngeni instrument.
Press and hold for 2 seconds to turn the SLP off.