Filling The Fryer With Solid Shortening; Thermostat Calibration; Fryer Shut-Down - Pitco frialator SG14 Installations- Und Bedienungsanleitungen

FILLING THE FRYER WITH SOLID SHORTENING

a. Make sure the drain valve is completely closed.
b. Cut the solid shortening into 1" (2.54CM) sqare cubes andcompletely pack fry tank up to oil level mark
with cubes making sure there are no air pockets.
c. 1. Solid State Thermostat: Switch melt switch to melt position. Turn the Thermostat
knob to desired temperature. Turn the power switch to the "ON" position.
(Note: if using solid shortening, set melt switch to the ON position)
2. Digital Controller: Press the
(Note: if using solid shortening, ensure digital controller is programming is set on the solid
shortening melt cycle setting, by following digital programming instructions in manual)
3. Computer Controller: Press the
(Note: if using solid shortening, ensure computer controller is programming is set on the solid
shortening melt cycle setting, by following digital programming instructions in manual)
d. Allow unit to heat to operating temperature, unit is now ready for use.

THERMOSTAT CALIBRATION

a. Set the thermostat dial, computer, or digital controller to 350
b. Remove fryer tube rack and place a thermometer 1" (2.54CM) above fryer temperature probe.
c. Compare thermometer reading to thermostat or controller setting, if readings are not close, contact
local warranty service agent.
d. When the calibration check is complete, remove the thermometer and replace the tube screen.

FRYER SHUT-DOWN

There are two shutdown modes of fryer operation, STANDBY and COMPLETE. The standby mode removes the ability
for the fryer's main burners to cycle. Complete shutdown turns off the gas supply to the fryer. Shut down the fryer by:
STANDBY Turn the thermostat or controller OFF. The cooker is now in Standby and can remain this way for only
brief periods of time. NEVER leave the cooker in standby overnight.
COMPLETE To completely shut down the cooker, push and turn the gas valve to the OFF position. The fryer is now
completely shut down and can be cleaned and filtered.
button on the controller panel to turn fryer ON,
button on the controller panel to turn fryer ON,
o
F (177
SOLID STATE THERMOSTAT
8
0
C).