Aventics HF03 Betriebsanleitung Seite 65

X0V, 8-pin plug
XPE, 8-pin plug
Marking
Logic supply
Sensor supply
Load supply
See Fig. 7
AVENTICS | HF03/HF02 | 1987765493–BDL–001–AB
Table 14: X0V plug pin assignments (reserve)
Pin Signal
All 8 0 V
Table 15: XPE plug pin assignment (reserve)
Pin Signal
All 8 PE
The plug inscription is on the inside of the 32 I/O box cover.
Fig. 7 shows a cutout of the plug layout.
All required bushings are supplied as screw terminals.
The X10 pin P24VI supply voltage must always be connected.
It serves as the power supply for the 32 I/O box logic.
The X10 pin supply logic voltage is supplied via electronic
switches to the plugs X1-X8 and XUS as sensor supply to the
US pin.
The XUS terminals can handle a maximum total current
of 2.1 A
By applying voltage to X10 terminals for pins P24V01-4, the
respective output drivers are supplied with power, byte-by-byte,
and thus can be used as outputs. The respective I/O byte can
only be used as an input if no voltage is applied to these
terminals.
Since the outputs can be read back, querying the inputs/outputs
can determine whether the corresponding load supply is on
or off.
Depending on the application, the load supply can be attached to
the terminals P24V01 to P24V04 as pre or post emergency off.
Assignment
Ground for all voltages
Assignment
Protective ground
65
Installation