Change Of Crystal - Reely 23 15 52 Bedienungsanleitung



14. Change of Crystal

In order to avoid a double channel assignment it may be necessary to change the crystals on your
remote control system. For reasons of operational safety, you should only use crystals that are explic-
itly recommended for the use of your remote control system by the supplier.
• Pull the holder for the transmitter crystal (1) on the back
of the transmitter housing (2) out of the holder, whilst
the transmitter is turned off.
• Take the transmitter crystal out of its plastic holder.
• Insert the replacement crystal (3) with a different chan-
nel in the same frequency band.
Please make sure that you place the right
crystal in the holder. Transmitter crystals are
normally marked with the letter T or TX (T =
"transmitter").
• Put the crystal holder (1) back into the transmitter.
• Whilst the receiving system is switched off, open the RC
box and lift the receiver (4) out of the box. In order for
the servo lever not to disturb the throttle servo, you can
turn the servo by hand to the brake position.
• Pull the reception crystal (5) out of the receiver by the
plastic flap.
The suitable replacement crystal for the receiver has to be marked with the same channel
name as the transmitter crystal. In addition it has the letter code R or RX (R = receiver) on
it.
• Insert the replacement crystal with the suitable frequency for the transmitter into the receiver.
• Switch on the transmitter and afterwards the receiver and check the function of the system.
66
2
3
1
5
4
Illustration 20