Reely 23 15 52 Bedienungsanleitung Seite 51

The upper two illustrations opposite show the final settings
of the throttle servo (1) when the operating lever for the
drive function (see illustration 1, pos. 8) was pulled from its
centre position up to the limit stop in the direction of the
handle.
The slide carburettor (2) is fully opened.
To illustrate this more clearly, the air filter was pulled off
the carburettor adapter. If need be, the position of the ad-
justing ring (3) can be changed, if the EPA value has to be
reduced too much.
The lower illustration shows the end position of the throt-
tle servo (1), when the operating lever for drive function is
pushed from its centre position forward to the limit stop.
The slide carburettor (2) is closed up to little slit and the
break lever is actuated with maximum force.
If need be, the rods can also be changed with an adjust-
ment ring (4) and thus the break function can be adjusted.
2
2
4
3
1
1
Illustration 10
53