A) Servo Direction Setting „Reverse - Reely HCP80 Bedienungsanleitung

To leave the function setting menu again and to return to the operating system, push the two buttons „UP" and
„DOWN" at the same time again.
When you have called a menu item in the function setting menu, it is possible to switch right to the adjacent
menu item with the button „UP" and „DOWN", which then has also been called already without having to take
the detour across the menu item display.
a) Servo Direction Setting „REVERSE"
Depending on the position of the servos, a control movement to the left on the transmitter may invoke a steering mo-
vement to the right. This is why the transmitter allows you to individually set and save the rotting or running direction
of every individual servo.
To set the servo running direction speed, proceed as follows:
• Call the function settings menu.
• The menu item „REVERSE SELECT" already has a black
background and can be called with the button „SELECT".
In the display you will see display items for the six control
functions with the respective currently set running directions.
„N" corresponds to the standard running direction of the ser-
vo and „R" to the reversed running direction. Below channel
1, there is an arrow pointing up, showing that this channel
can now be set.
• Pushing the buttons „INC (+)" or „DEC (-)" sets the described
servo running direction at channel 1. The setting is saved au-
tomatically.
• Push the button „SELECT" to switch to the second channel.
The arrow pointing up jumps under the second channel.
• The second channel is set according to the same pattern as
the first one.
• Repeat the above procedure until the running directions of all
six servos/channels have been programmed.
• Push the buttons „UP" and „DOWN" at the same time to re-
turn to the overview of the function setting menu.
Figure 32
97