Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Range Extender To Rise Hydro; Operation Of The Range Extender; Battery Level Visualization - Orbea Blue Paper Rise Hydro 2022 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für BLUE PAPER RISE HYDRO 2022:
Inhaltsverzeichnis
90 | ORBEA
CONNECTING THE RANGE EXTENDER
TO RISE HYDRO
Turn the safety tabs of the Range Extender cable coun-
Open the bicycle charging port and connect the Range
Turn the cable´s safety tabs clockwise to lock the cable
To disconnect the Range Extender cable or to remove the
the cable´s safety tabs and carefully pull from the cable´s
TECHNICAL MANUAL
If Rise was On when connecting the Range
Extender to the bicycle, the system will turn
itself Off and you will need to turn Rise On
This happens so the system can reboot and
recognize the Range Extender as part of the
If you were recording an activity with Garmin
Connect using Orbea RS Toolbox, this will
have no effect on the data recorded in the
Once you turn Rise on, the Range Extender
If the Range Extender is disconnected when
the bicycle is On, the bicycle will turn itself
Off and it will be necessary to turn the bicy-
reboot and recognize the internal battery as
B LUE PAP ER R I SE · H YD R O 2022
OPERATION OF THE
RANGE EXTENDER
When using Rise with a Range Extender connected to the
system, the motor will only draw power from the Range

BATTERY LEVEL VISUALIZATION

Combined battery level:
When a Range Extender is connected to Rise, the system
calculates the total capacity of both the Range Extend-
er and the internal battery (792 Wh) and the remaining
battery level information for the system will take into ac-
count the charge left on both batteries out of the total
When the Range Extender is connected to the bicycle
and its charge is depleted, the system will show, by
means of the available methods (displays, junction or RS
Toolbox) the available charge in the internal battery only,
accounting for the capacity of the internal battery alone
and not the internal battery and the Range Extender sys-
BATTERY
BATTERY CHARGE LEVEL
Internal battery RS (540Wh)
Range Extender (252 Wh)
BATTERY
BATTERY CHARGE LEVEL
Batería interna RS (540Wh)
Range Extender (252 Wh)
ORBEA | 91
When there is no charge left in the Range Extender, the
internal battery will start powering the motor if it had any
The combined charge level will be visible trough the EW-
EN100, the SC-EN800 or SC-E7000 displays or the Or-
Read the Checking the Battery Level section on Use of
Rise chapter of this manual to learn more about the dif-
SYSTEM CHARGE LEVEL
50%
396 Wh of 792 Wh
SYSTEM CHARGE LEVEL
84%
666 Wh of 792 Wh
E N
Inhaltsverzeichnis
loading

Inhaltsverzeichnis