Hologic FluentPro Bedienungsanleitung Seite 82

Table 3: Real-time Display, System Faults
Fault Message(s)
Temperature Fault 1-4
Sensor Data Missing
FloPak Sensor Data Missing
Memory Fault 2
System Watchdog Timeout
Power Fault 1-6
Initialization Fault 1-8
Hardware Fault 1-7
System Fault 1-4
Internal Communication Fault
Calibration Fault 1-4
Recovery Fault 2
Fluid Scale Fault 1-4
Waste Scale Fault 1-2
In-FloPak Fixed Pin Not Detected
Inflow Sensor Fault 1-2
Inflow Motor Stopped
Inflow Direction Fault
Inflow Speed Fault
Outflow Sensor Fault 1-2
Outflow Motor Stopped
Outflow Direction Fault
Outflow Speed Fault
Pressure Sensor Fault 1-4
MyoSure Motor Stopped
English
Fluent Pro Fluid Management System
5.3.10.3.1 System Fault Messages
Turn system off. Allow 5 minutes for system to cool down before turning
Turn system off and on. Upon turning system back on, Last Procedure
data may be incorrect. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Turn system off and on. If problem persists, call Technical Support.
Troubleshooting
Resolution
the system on. If problem persists, call Technical Support.
Sensor calibration required. Call Technical Support.
FloPak sensor calibration required. Call Technical Support
69