Touchscreen Monitor; Touchscreen Icons - Hologic Fluentpro Bedienungsanleitung

1.3.3.1
1.3.3.2
1.3.3.3
6
Fluent Pro Fluid Management System
Fluid Bag Hooks
Fluid Bags (not included) containing hypotonic, isotonic, ionic and non-ionic distention fluids
hang from the Fluid Bag Hooks located on the IV pole at the top of the Fluent Pro Fluid
Management System. Each Fluid Bag Hook can support up to three (3) liters of fluid. Hang
only a single Fluid Bag on the Fluid Bag Hooks at a time.
The In-FloPak TM contains a bag spike which connects the In-FloPak to the Fluid Bag. Fluid is
pulled from the Fluid Bag through the In-FloPak and delivered through the hysteroscope
inflow channel into the patient.
WARNING!
Do not place excessive force or weight on the Fluid Bag Hooks. Doing so may result in an
inaccurate fluid deficit value, causing risk to patient safety.
WARNING!
When performing monopolar hysteroscopic electrosurgery, the distension medium must be
electrically non-conductive. Examples include glycine, sorbitol, and mannitol.
WARNING!
When performing bipolar electrosurgical resection procedures, the distension medium may be
isotonic. Examples include saline and lactated Ringer's solution.

Touchscreen Monitor

The Touchscreen Monitor includes two system speakers and the Touchscreen User
Interface. Tilt and swivel the monitor for optimal viewing.
Caution!
Only use the Handle to move or position the Fluent Pro Fluid Management System. Do not
pull or push the system with the IV pole or Touchscreen Monitor.
1.3.3.2.1 Touchscreen User Interface
Use the Touchscreen User Interface to configure and view system information,
set the deficit limit, prime the system, and make other adjustments as needed.
The Touchscreen prompts perform initial setup tasks (such as Hang Fluid Bag)
and displays when the task has been completed.
1.3.3.2.2 Touchscreen Notifications, Alerts and Faults
The Touchscreen User Interface displays notifications, alerts and faults. The
system continues to run when notifications are displayed, pauses when an alert
is displayed, and requires a system restart when a fault is displayed. For a list of
notifications, and alerts along with troubleshooting refer to Section 5.3.10.

Touchscreen Icons

1.3.3.3.1 System Launch Screen
Introduction English