Positioning The System; Connecting The Power Cord; Figure 11: Positioning The System - Hologic Fluentpro Bedienungsanleitung

Positioning the System

2.2
2.2.1 Use the Handle to push, pull, or steer the system.

Figure 11: Positioning the System

Only use the Handle to move or position the Fluent Pro Fluid Management System. Do not pull or
push the system with the IV pole or Touchscreen Monitor.
Do not lean on the Handle. Leaning may cause the system to tip.
Do not place excessive force or weight on the Fluid Bag Hooks. Doing so can result in an inaccurate
fluid deficit value, causing risk to patient safety.
2.2.2 Position the Fluent Pro Fluid Management System to allow the MyoSure tissue removal device (TRD)
drive cable to hang in a large arc with no bends, loops, or kinks.
2.2.3 The ideal placement of the Fluent Pro Fluid Management System is behind the Physician either to the
right (if right-handed) or to the left (if left-handed).
2.2.4 Inspect the console for noticeable severe damage. This includes severe damage to the supply arm,
supply bag hooks, and waste bag hooks. If severe damage is found discontinue use of the system. To
use the device, perform a Scale Calibration Check following steps detailed in Section 6.1.1.

Connecting the Power Cord

2.3
2.3.1 Unwrap the Power Cord from the Power Cord Wrap on the rear of the Fluent Pro Fluid Management
System.
2.3.2 Connect the Power Cord to the Power Cord Port on the rear of the Fluent Pro Fluid Management
System.
2.3.3 Plug the Power Cord directly into a hospital grade wall outlet with the appropriate power for the Fluent
Pro Fluid Management System. The Power Button will illuminate orange.
2.3.4 Position the Fluent Pro Fluid Management System to ensure that the Power Cord does not obstruct
16
Fluent Pro Fluid Management System
Caution!
Caution!
WARNING!
Procedure Setup English