Replacing The Waste - Hologic Fluentpro Bedienungsanleitung

Replacing the Waste Bag
3.8.2
3.8.2.1
3.8.2.2
3.8.2.3
44
Fluent Pro Fluid Management System
3.8.1.6.1.2 The total volume hung on each Fluid Bag Hook should not exceed
3L of fluid.
3.8.1.6.1.3 Spike the new Fluid Bag.
3.8.1.6.1.4 Open clamp on the new Fluid Bag.
3.8.1.6.1.5 Close the clamp on the empty Fluid Bag.
3.8.1.6.2 Two Fluid Bags on Fluid Bag Hooks (One Bag Unclamped)
3.8.1.6.2.1 Remove the non-active empty Fluid Bag and unspike.
3.8.1.6.2.2 Hang a new Fluid Bag on the vacant Fluid Bag Hook.
3.8.1.6.2.3 Spike the new Fluid bag.
3.8.1.6.2.4 Unclamp the Fluid bag tubing on the hanging full Fluid Bag when
ready.
3.8.1.6.2.5 Clamp the Fluid Bag tubing on the empty Fluid Bag.
3.8.1.6.3 Two Fluid Bags on Fluid Bag Hooks (Both Bags Unclamped)
3.8.1.6.3.1 Clamp Fluid Bag tubing on either Fluid Bag.
3.8.1.6.3.2 Remove the clamped Fluid Bag and unspike.
3.8.1.6.3.3 Hang a new Fluid Bag on the vacant Fluid Bag Hook.
3.8.1.6.3.4 Spike and unclamp new Fluid Bag when ready.
3.8.1.6.3.5 Repeat with second empty bag (if needed) or clamp when empty.
Replace the Waste Bag when the Waste Bag is almost full or when the system alerts you.
The system will pause when approximately 6000mL of fluid is in the Waste Bag.
If the system is running, touch the 'PAUSE' icon to pause the system.
WARNING!
Changing the Waste Bag without pausing the system may lead to overestimation of deficit.
Remove the Waste Bag Connector from the Waste Bag by rotating the Connector
counterclockwise.
During Procedure English