Invacare Aquatec Ocean Ergo Gebrauchsanweisung Seite 14

Aquatec® Ocean Ergo / Ocean Ergo XL / Aquatec® Ocean 24" Ergo / Ocean 24" Ergo XL
4.3.4 Setting Armrest Height
The height adjustment procedure is the same for the
right and left armrest.
1. Open the belt buckle of the backrest cover which is passed
on the inside of the backrest frame.
2. Open the belt buckle on the backrest cover, which is
above the armrest.
When adjusting to a lower position the belt
beneath the armrest must be opened.
3. Pass this belt on the inside of the backrest frame and close
it again.
B
4. Remove cap A.
5. Fold up armrest B to pull it off the
A
C
6. Remove screws D from armrest
F
G
7. Remove securing clamp E with nuts
C
E
D
14
armrest bracket C.
bracket C with supplied Allen key.
F from the inside of the backrest
frame.
The nuts are inserted loosely
into the securing clamp and
may drop out.
8. To reinstall armrest bracket and securing clamp at desired
position, insert screws D into armrest bracket and guide
them through the desired holes in the backrest frame.
The smaller holes on the inside of the backrest
frame fix the securing clamp.
9. Place the securing clamp in such way that the fixing G of
securing clamp engages in smaller hole.
10. Tighten screws D with 5 - 6 Nm and nuts F.
11. Reinstall armrest B on bracket C.
B
12. Fold down armrest.
13. Reinstall cap A.
C
14. Pass the open belt of the backrest
A
To install accessories / options, the third belt from the
top can be opened and the backrest cover can be
passed by the backrest frame from the inside.
cover on the outside of the backrest
frame, close belt buckles and
tighten all the belts.
1659301-G