Coloplast Isiris a Bedienungsanleitung Seite 14

4. Inspection and preparation of Isiris α
4.1. Visual inspection of Isiris α
1. Check that the pouch seal is intact.
2. Make sure to remove the protective sheath from the insertion cord.
3. Check that there are no impurities on the product.
4. Check that there is no evidence of shipping damage or other damage such as rough
surfaces, sharp edges or protrusions which may harm the patient.
4.2. Inspection of the Image
4.3. Preparation of Isiris α
1. Carefully slide the deflection lever up and down in each direction until it stops.
Confirm that the deflective tip functions smoothly and correctly.
2. Slide the deflection lever slowly to its neutral position. Confirm that the deflective
tip returns smoothly to a neutral position.
3. Activate the grasper by pressing the button and observe that the opening,
closing and grasper retraction movements are completely executed. Perform this
check in a straight position and in a full up and down deflection.
4. Connect to the irrigation line, turn on irrigation and make sure that irrigation
flushes through the scope.
5. Aspiration might be required during the procedure. Make sure to prepare a 50 cc
syringe for this. When required, adapt the syringe to Isiris α and apply an aspiration
force according to the wanted effect. Disconnect, empty the syringe and reconnect
it should there be a larger quantity of liquid to aspirate.
4.4. Additional preparations
In addition to the Isiris α, prepare the following:
• Medical grade water based lubricant
• Irrigation line with Luer connector and irrigation bag
• 50 cc syringe
14
492880500_Isiris IFU_Multi_V01_202205_TCC 11251.indb 14 492880500_Isiris IFU_Multi_V01_202205_TCC 11251.indb 14
0086
1. Connect Isiris α to Isiris
Monitor by plugging the white
connector with red arrow into
the corresponding red port on
Isiris Monitor.
2. The connector must not be
twisted when inserted into the
plug - this could potentially
damage the scope connector
or the monitor plug.
3. Verify that a live video image
appears on the screen.
4. Point the distal end of Isiris
α towards an object, e.g. the
palm of your hand.
5. Adjust the image brightness
and contrast preferences on
Isiris Monitor if necessary –
please refer to the Isiris Monitor
Instructions for use for details.
It is not possible to adjust the
white balance since this is
predefined in the system.
6. If the object cannot be seen
clearly, wipe the lens at the
distal end using a sterile cloth.
02/06/2022 17:47 02/06/2022 17:47