Siemens SINUMERIK ONE Programmierhandbuch Seite 242

Messvarianten
4.3 Werkstück messen (Fräsen)
Beispiel 1: Transformation auf Basis kinematischer Kette:
-------------------------------------------------------------------
--------------------------------------
2 :
Time: 08:59:42
Results measure: Kinematic measure complete /CYCLE9960
Variant
Measuring plane: G17
Name / number : HEAD_CA_Y100/2
Rotary axis 1
Position of rotary axis 2: 30
Rotary axis 2 :
Position of rotary axis 1: 0
-------------------------------------------------------------------
--------------------------------------
Difference of measure:
max Value
min Value
C1[deg]
120.0000
180.0000
240.0000
0.0000
0.0000
0.0000
Difference of vector
before:
MC1_OFFSET_2_CORR
MA1_OFFSET_2_CORR
Results:
Difference of vector:
MC1_OFFSET_2_CORR
MA1_OFFSET_2_CORR
Overwrite kinematics data record, yes -> NC start, no -> reset
242
: S_MVAR=11400
: C1 start:
A1 start:
A1[deg]
30.0000
30.0000
30.0000
0.00000
30.0000
90.0000
120.000 final:
30.000 final: 90.000
X [mm] Y [mm]
0.03663 0.01208
-0.02591 -0.05250
X [mm] Y [mm]
-0.02591 0.00373
-0.00379 -0.03623
0.03663 -0.05250
0.00000 0.00000
0.00682 -0.00950
0.00505 0.01208
X [mm] Y [mm]
0.00000 0.00000
0.00000 0.00000
X [mm] Y [mm]
0.00470 -0.00449
-0.01612 -0.00129
Programmierhandbuch, 07/2021, A5E48061510A AD
240.000 no.:3
no.:3
Z [mm]
0.04873
0.00000
Z [mm]
0.01599
0.03088
0.04800
0.00000
0.04377
0.01473
Z [mm]
0.00000
0.00000
Z [mm]
0.15641
-0.25343
Messzyklen