3M Bair Hugger 775 Bedienungsanleitung Seite 10

Specifications
Physical Charact eristics
DIMENSIONS
13" high x 13" deep x 14" wide (33 cm high x 33 cm deep x
36 cm wide)
WEIGHT
16 lb (7.3kg)
RELATIVE NOISE LEVEL
53 dBA (High fan setting)
48 dBA (Low fan setting)
HOSE
Flexible; Length: 80" (203 cm)
Length: 80" (203 cm)
FILTRATION SYSTEM
MERV 14*
*See Frequently Asked Questions on Filtration (p. 347)
RECOMMENDED FILTER CHANGE
Every 12 months or 500 hours of use.
MOUNTING
Can be clamped to an IV pole, placed on a hard surface, or mounted
to the rolling cart accessory.
Temperature Characteristics
RECOMMENDED OPERATING ENVIRONMENT TEMPERATURE
15°C-25°C
HUMIDITY
Max relative humidity 80% (up to 31°C) decreasing linearly to 50%
relative humidity at 40°C.
ALTITUDE
Max 2,000m
TEMPERATURE CONTROL
Electronically controlled
HEAT GENERATED
High fan setting: 1600 BTU/hr (average), 470 W (average)
Low fan setting: 1330 BTU/hr (average), 390 W ( average)
OPERATING TEMPERATURES
Average temperatures at the end of the hose:
HIGH: 43° ± 1.5°C (109.4° ± 2. 7°F)
MED: 38° ± 1.5°C (100.4° ± 2.7°F)
LOW: 32° ± 1.5°C (89.6° ± 2.7°F)
TIME TO REACH OPERATING TEMPERATURE
2 - 5 minutes (dependent on blanket model)
Time required for the contact surface temperature to heat up from
23 ± 2°C to 37°C (73 ± 2°F to 99°F).
STORAGE/TRANSPORT TEMPERATURE
-20°C to 45°C (-4°F to 113°F)
Store all components in a cool, dry place when not in use.
8
Classification
• Protection against electric shock: Class I Medical Electrical
Equipment with Type BF applied part.
• Protection against ingress of water: Ordinary equipment
(IPX0)
• Mode of operation: Continuous operation.
Diagnostics
• A qualified service technician can perform over-
temperature detection system testing, temperature output
testing, operating temperature calibration, and fault code
troubleshooting.
Not suitable for use in the presence of flammable anesthetic mixtures
with air or with oxygen or nitrous oxide.
MEDICAL–GENERAL MEDICAL EQUIPMENT AS TO
ELECTRIC SHOCK,FIRE AND MECHANICAL
HAZARDS ONLY IN ACCORDANCE WITHANSI/AAMI
ES 60601- 1 (2005) + AMD (2012), CAN/CSA-C22.2
No.60601-1 (2008) + (2014 ), IEC 80601-2-35 (2009)
+ AMD (2016), IEC60601-1-6:2010 (T hird E dition) +
A1:2013, IEC 60601-1-8:2008 (Second Edition) +
A1:2012; Control No. 4HZ8