Remote Control - Dometic Buttner POWER & CONTROL MT ICC Montage- Und Bedienungsanleitung

Control panel on the device
Item in
fig. 3 A,
Designation
page 4
1 Power indication LEDs
2 Operating mode indication LEDs
3 State of charge indication LEDs
(100 %, 80 %, 50 %, 0 %)
4 Switch (3-stage) for AC input current
limitation

Remote control

Item in
fig. 3 B,
Designation
page 4
1 Power indication LEDs
2 Operating mode indication LEDs
3 State of charge indication LEDs
(100 %, 80 %, 50 %, 0 %)
4 Operating mode selection button
(P button)
Power indication LEDs
Operating mode Description
Inverter operation Indication of output power deliv-
ered (in %)
Note: LED turns red when the
output power exceeds the
continuous output power value
(P
Mains operation Indication of momentary
charging current related to the
maximum charging current of
the device (in %)
18
)
nom
Operating mode indication LEDs
LED
"Charger
ON"
(charger
on)
"Inverter
ON"
(inverter
on)
"Line"
(AC input)
4445103626
Status Description
On (green) Mains operation
On (red) Charger deactivated
Flashing Error (see chapter "Error
(red) indication" on page 30)
Off No mains operation
On (green) Inverter operation (continu-
ous mode or mains sup-
port/ power boosting)
On (red) Inverter deactivated
Flashing Inverter operation (auto-
(green) matic mode or mains sup-
port/ power boosting)
Flashing Error (see chapter "Error
(red) indication" on page 30)
Off No inverter operation
On (green) AC input approved, AC
transfer switch closed
On (red) AC transfer switch disabled
Flashing AC input present and
(green) within range, device
synchronizes
Flashing AC input present but out of
(red) range (see chapter "Error
indication" on page 30)
Off No AC input present, AC
transfer switch opened
EN