Operating The Device Safely - Dometic Buttner POWER & CONTROL MT ICC Montage- Und Bedienungsanleitung

• Lay the cables so that they cannot be damaged
by the doors or the hood.
Crushed cables can lead to serious injury.
A
NOTICE! Damage hazard
• Use ductwork or cable ducts if it is necessary to
lay cables through metal panels or other panels
with sharp edges.
• Do not lay the 230 V mains cable and the 12 V
DC cable in the same duct.
• Do not lay the cable so that it is loose or heavily
kinked.
• Fasten the cables securely.

Operating the device safely

!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Electrocution hazard
• Before starting the device, ensure that the
power supply line and the plug are dry and the
plug is free from rust or dirt.
• Always disconnect the power supply when
working on the device. Do not disconnect any
cables when the device is still in use.
• Observe that parts of the device may still con-
duct voltage even if the fuse has blown.
• Do not disconnect any cables when the device is
still in use.
A
NOTICE! Damage hazard
• Ensure that the air inlets and outlets of the device
are not covered.
• Ensure a good ventilation.
• Do not pull on the connection cables.
• The device shall not to be exposed to rain.
14
Safety precautions when handling
batteries
!
WARNING! Failure to obey these
warnings could result in death or
serious injury.
Risk of injury
• Batteries contain aggressive and caustic acids.
Avoid battery fluid coming into contact with
your body. If your skin does come into contact
with battery fluid, wash that part of your body
thoroughly with water.
If you sustain any injuries from acids, contact a
doctor immediately.
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Risk of injury
• When working on batteries, do not wear any
metal objects such as watches or rings.
Lead acid batteries can cause short circuits
which can cause serious injuries.
• Wear goggles and protective clothing when you
work on batteries. Do not touch your eyes when
you are working on batteries.
Explosion hazard
• Never attempt to charge a frozen or defective
battery.
Place the battery in a frost-free area and wait until
the battery has acclimatised to the ambient tem-
perature. Then start the charging process.
• Do not smoke, use an open flame, or cause
sparking near the engine or a battery.
A
NOTICE! Damage hazard
• Only use rechargeable batteries.
• Prevent any metal parts from falling on the bat-
tery. This can cause sparks or short-circuit the
battery and other electrical parts.
• Ensure that the polarity is correct when connect-
ing the battery.
• Follow the instructions of the battery manufac-
turer and those of the manufacturer of the system
or vehicle in which the battery is used.
• If you need to remove the battery, first discon-
nect the ground connection. Disconnect all con-
nections and all consumers from the battery
before removing it.
• Only store fully charged batteries. Recharge
stored batteries regularly.
4445103626
EN