Appendices C; Remote Control Operations - Dometic SI 1500 Benutzerhandbuch

7

Appendices C

7.1

Remote control operations:

System Configuration
7-1-1. Plug the 9-pin D-SUB connector of the remote controller in the
RS-232 port of the Inverter.
7-1-2. NA
LED Indications
7-1-3. Turn on the switch of the Inverter, there will be two short beep
sounds from the Inverter. All LEDS will be ON and, one second
later, there will be a short beep sound. The amber, green and
red LEDS of remote controller will be on for 0.5 second then off
sequentially. The Inverter is then in the OFF mode. The amber
LED will be blinking every 2~3 seconds.
7-1-3-1. Remote Control LEDS
Color / Status
Green "ON"
Green "Blinking"
Amber "ON"
Amber "Blinking"
Green - Power saving enable
Amber - Power saving disable
ON - Power On
Blinking - Power Off
18
Power Saving Power Output
Enable
Enable
Disable
Disable
ON
OFF
ON
OFF