Dometic Buttner POWER & CONTROL MT ICC Montage- Und Bedienungsanleitung Seite 26

Switching to standby mode
I
NOTE
• In standby mode the device continues
to consume standby power (see chap-
ter "Technical Data" on page 33).
• The device automatically switches to
standby mode when the load at the
output is <25 W for more than
10 minutes in automatic mode (inverter
operation).
➤Press the P button on the remote control twice
to switch the device to standby mode.
Switching off
I
NOTE
• The device automatically switches off if
no mains is available.
Optional: Delayed shutdown with trig-
ger input connected in factory default
setting (see chapter "Trigger input" on
page 20).
• Switch off the device when not in use
to avoid unnecessary power consump-
tion.
➤Switch off the device using the remote switch
connected to the remote switch input.
Note: Ensure that the remote switch input is
activated (see chapter "Activating or
deactivating remote switch input" on page 25).
Limiting the mains input current
The device can be limited to the maximum avail-
able mains input current in three setting levels.
I
NOTE
AC input current boost remains active in
all setting levels. The AC input current
boost supplements the missing power
up to the maximum surge power when
the connected loads exceed the avail-
able mains input power.
➤Set the switch for AC input current limitation (see
chapter "Control panel on the device" on
page 18) to the desired position.
26
Switch
position
Setting the night mode
I
NOTE
When using the night mode the system
stays in this mode for 10 hours and then
automatically returns to normal opera-
tion.
In night mode the charging power is reduced by
50 % and the cooling fan is switched to the lowest
speed for quiet operation. The LEDs on the control
panel and the remote control are darkened.
➤Press and hold the P button on the remote
control for at least 6 seconds to activate the
night mode.
✔ 2 beeps sound. Night mode is activated.
➤Press the operating mode selection button
again or turn off the device to interupt night
mode prematurely.
Setting the automatic mode
In automatic mode the inverter operates depend-
ing on the load at the AC output:
• > 25 W: Inverter on
• < 25 W (for 10 minutes): Inverter switches to
standby
➤Press the operating mode selection button (see
chapter "Remote control" on page 18) to set
automatic mode in inverter operation.
4445103626
Setting
3 A (at 230 V)
Maximum current (≤16 A)
6 A (at 230 V)
EN