Control Elements - Dometic Waeco SinePower MSI912 Montage- Und Bedienungsanleitung

SinePower
 Incorrect polarity protection: The incorrect polarity protection prevents
the wrong polarity when connecting the inverter.
 Fuses (MSI 1812T and MSI 1824T only): The LED on the inverter indi-
cates an operating fault (constant red light). The fuse in the device must
be pressed in again by hand after it is triggered.
NOTE
I
The individual values are found in the chapter "Technical data" on
page 52.
The device can also be configured with a PC via an RS 232 interface and us-
ing the DIP switches on the device.
The inverter can be switched to an energy-saving mode to prevent the con-
nected battery from discharging too quickly.
The inverter can be easily controlled using the remote control (accessory).
The SinePower MSI1812T and SinePower MSI1824T inverters are fitted
with a 230 Vw priority circuit. If an external 230 Vw voltage is available, this
will have priority. If no external 230 VAC voltage is connected, then the con-
nected battery will be used as the power supply.
7.1

Control elements

The inverter has the following connections, displays and control elements on
the back:
No. in
fig. 5, Designation
page 4
1 Terminal
2 RS232 port,
REMOTE port
3 POS+
4 NEG–
5 Earth terminal
EN
Description
Setup operation via remote control
Serial RS232 port for connecting to a PC
Positive terminal
Negative terminal
Earthing on the vehicle bodywork
Technical description
39