Dometic Buttner POWER & CONTROL MT ICC Montage- Und Bedienungsanleitung Seite 13

• Do not use the device in wet conditions or sub-
merge in any liquid. Store in a dry place.
• Only use accessories that are recommended by
the manufacturer.
• Do not modify or adapt any of the components
in any way.
• Disconnect the device from the power supply:
– Before each cleaning and maintenance
– After every use
– Before changing a fuse
– Before carrying out electrical welding work or
work on the electrical system
Fire hazard/Flammable materials
• In event of fire, use a fire extinguisher which is
suitable for electrical devices.
Health hazard
• This device can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use
of the device in a safe way and understand the
hazards involved.
• Electrical devices are not toys.
Always keep and use the device out of the reach
of very young children.
• Children must be supervised to ensure that they
do not play with the device.
• Cleaning and user maintenance shall not be
made by children without supervision.
A
NOTICE! Damage hazard
• Before start-up, check that the voltage specifica-
tion on the data plate is the same as that of the
power supply.
• Ensure that other objects cannot cause a short
circuit at the contacts of the device.
• Ensure that the negative and positive poles
never come into contact.
Installing the device safely
D
WARNING! Failure to obey these
warnings could result in death or
serious injury.
Explosion hazard
• Never mount the device in areas where there is a
risk of gas or dust explosion.
• Only install and operate the device in closed,
well-ventilated rooms.
EN
• Do not install or operate the device under the
following conditions:
– In salty, wet or damp environments
– In the vicinity of corrosive fumes
– In the vicinity of combustible materials
– In areas where there is a risk of explosions
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Risk of injury
• Ensure that the device is standing firmly.
The device must be set up and fastened in such
a way that it cannot tip over or fall down.
• When positioning the device, ensure that all
cables are suitably secured to avoid any form of
trip hazard.
A
NOTICE! Damage hazard
• Ensure that the mounting surface is capable of
supporting the weight of the device.
• Always use sockets which are grounded and
secured by residual current circuit breakers.
• Do not place the device near heat sources (heat-
ers, direct sunlight, gas ovens, etc.).
• Set up the device in a dry location where it is pro-
tected against splashing water.
Safety when connecting the device
electrically
D
DANGER! Failure to obey these warn-
ings will result in death or serious
injury.
Electrocution hazard
• For installation on boats:
If electrical devices are incorrectly installed on
boats, corrosion damage might occur. Have the
device installed by a specialist (marine electri-
cian).
• If you are working on electrical systems, ensure
that there is somebody close at hand who can
help you in emergencies.
!
WARNING! Failure to obey these
warnings could result in death or
serious injury.
Electrocution hazard
• Observe the recommended cable cross-sec-
tions.
4445103626 13