Tektronix DC 5010 Anleitung Seite 68

Operating Instructions-DC 501 0
TMANUAL (TIME MANUAL)
Type:
Operational
Syntax:
TMAN
TMANUAL
Discussion:
The TMANUAL command sets up the DC 5010 to mea-
sure time in a "stop watch" type operation. Measurement is
started by the "START" command and is halted by the
"STOP" command. If in "DT GATEn mode, TMANUAL oper-
ation is started and stopped alternately using the Group Ex-
ecute Trigger <GET> interface message.
See discussions of START, STOP, and DT commands.
See discussion of <GET> in Sending IEEE lnterface
Control Messages in this section.
TMANUAL (TIME MANUAL)
TOTALIZE
Type:
Operational
Syntax:
TOT A (argument is optional)
A+B
A-B
Examples:
TOTALIZE A+B
TOT A-B
TOT A
Discussion:
This command sets up the DC 501 0 to measure and cal-
culate the total number of events on the specified channel or
channels. The measurement is started by the "START"
command and stopped by the "STOP" command. If in "DT
GATE" mode, TOTALIZE operation is started and stopped
alternately using the Group Execute Trigger <GET> inter-
face message.
In the A+ B and A- B modes, the DC 50'1 0 will only
count B events after the first valid A event.
If no argument is specified, TOT A is assumed.
See discussions of START, STOP, and DT commands.
See discussion of <GET> in sending in IEEiE lnterface
Control Messages in this section.
TOTALIZE
REV JUL 1983